ReviverSoft

Answers

How do i get a netgear expander in a connected network does not accept the security key Asked by Keijo Ahola 2017/09/14 07:05 Crashes
i like this question 0 Like It Follow	Forget the whole thing Operating System: Windows 8.1 Answer this question 1024 Add your Answer Cancel
best answer
	Answered by Christian Velasco 2017/09/14 09:59 Get permalink
	Moikka Keijo, Thank you for posting my concerns here. I'm sorry about the problem you are experiencing. Could you share additional information about the problem, including the product name? Screenshots be helpful as well. Looking forward to hearing from you. With respect, Christian Comments Commented by Keijo Ahola 2017-09-14 10:46:58 Yes I put the name of the product in the past it was the NETGEAR WiFi Range Extender 300Mbps Expander question was how do I get it measures the combined network and when does it concern the supplied security key 4GN26C5A00284 this I have tried many times. Add your comment Cancel

Answered by

2017/11/05 13:00

Hi Keijo,

Please use the below steps to resolve the issue. If you have a NETGEAR WiFi Extender with an Ethernet port (EX6100, for example):

Use a computer to connect to NETGEAR WiFi Extender via Ethernet cable.
Login to the web user interface of your NETGEAR WiFi Extender using http://myWiFiext.net.
You will be prompted to enter a username and password.
Default login credentials are:
- Username: admin
- Password: password
  Note: Username and password are case sensitive.
Once you have successfully logged in, go to Setup > Wireless Settings.
Check the value in the Password (Network Key) field under Security Options.
If the password is not same as your Access Point (AP) password, change it so it matches your Access Point password.
Click Apply. (Extender and AP password need to match)
Reconnect your Wi-Fi devices to the NETGEAR WiFi Extender using either the WPS button or manual connection.

If you have a NETGEAR WiFi Extender without an Ethernet port (WN1000RP, for example):

Reset your NETGEAR WiFi Extender back to factory default settings.
To do this, press and hold the Factory Settings button on the side panel for 7 seconds.
Connect via Wi-Fi to your NETGEAR WiFi extender
Login to the web user interface of your NETGEAR WiFi Extender using http://myWiFiext.net.
You will be prompted to enter a username and password.
Default login credentials are:
- Username: admin
- Password: password
Note: Username and password are case sensitive.
Walk through the setup wizard to setup your connection to your Access Point. (Do not use WPS when reconnecting to the Access Point)
Reconnect your Wi-Fi devices to your NETGEAR WiFi Extender using either the WPS button or manual connection.

Regards,
Lokesh

Edit your answer

Cancel

Add your comment

Cancel

ReviverSoft Answers is a place to ask any question you have about your computer and have it answered by the expert community.

Ask your question to the community now